¡ô The density of nozzle is based on circumstances of workshop.
¡ô use clear neutral water.
The filtered water is pressed into 0-5Mpa by the imported special pump,then sent to the nozzle through high pressure pipe,and sprayed among the whole space after atomization. 
¢Ù ¡¢Integrated movement:
Cuts off the water supply the protection system, the humidity automatic control system, the electrical machinery over-load
protection system, stable is reliable, realizes nobody to melt the management.
¢Ú¡¢Reduces the energy consumption:
Directly take the hydraulic pressure as the power, does not needsupporting facility and so on air compressor.
The electrical machinery power is 3 kilowatts.
¢Û¡¢Reliable Canada wet:
Uses the tertiary water disposal system, fully solves the water quality to the system the influence, uses the precise
processing the import micro fog spray nozzle, the resistance to wear is good,Does not have the water drop, the atomization
effect is good,the granule diameter is only 5 microns.
¢Ü¡¢Adds the moisture content in a big way:
Adds the moisture content to be possible to increase according to the spray nozzle quantity increases.
¢Ý¡¢(NEW) the humidity multi- spots control system
to the different region, the different working procedure may use the humidity multichannel distinction automatic control,
satisfies the customer accuracy control humidity the request (ordering).
¢Þ¡¢(NEW) water heating and controlsystem:
The main engine carries on water tank in water heats up, causes the system when the low temperature environment
uses the hot water atomization, the winter may use for to enhance the workshop temperature.
Module name |
main component |
Technology standard |
water disposal system |
three filters |
partical size is 10 microns after filtration |
cistern of half ton |
|
high-pressure system |
high pressure plunger pump |
imported special pump from USA |
regulator |
Range:0-5Mpa |
solenoid valve |
|
pipe |
nylon pipe |
¦µ9.52mm |
nozzle |
nozzle |
imported special pump from TW |
control system |
humidity controller manual |
Range £º0.1-99.9%RH |
protect system |
motor preventing for overload |
|
motor preventing for anhydrous |
|
To ensure uniformity workshop humidity, the nozzle is installed on the same high level. evenly throughout the workshop will also be divided into several small regional 10-15 m 2. 10-15 m 2 area in each district to ensure the installation of a nozzle and nozzle height of 4.0m from the ground. in the distance from the main water pipes and high voltage power supply mainframe 1m range. humidity control device can be left unattended in the middle of any part of the workshop will automatically adjust in RH30-90% humidity.
¡ô Textile profession: cotton spinning, wool spinning, silk spin, hemp spins, chemical fiber, system thes
¡ô Printing profession: paper material wet balance, prints the workshop, binds, packing.
¡ô Tobacco profession: leaf tobacco minute chooses, resurgence, to divide chooses, to cut the silk duplicate, roasts,
cigarette, the packing
¡ô Electron purification: pure room, the accumulator cell solidify, semiconductor chip manufacture
¡ô Cultivation profession: Greenhouse, botanical garden, edible fungus cultivation
¡ô Biology drugs manufacture: laboratory, the production workshop.
¡ô Store in a storehouse the profession: The fruits and vegetables maintain freshness, dangerous material depositing,
the books file, the medicine, the cultural relic.
¡ô Ferrous metallurgy: In front of the stove decreases temperature the dust removal
¢Ù¡¢Ambient temperature: Normal work ambient temperature for 0-40¡ãC.
¢Ú¡¢Water source: Uses the clean neutral running water.
|
